Vektor PC Software

With the Vektor PC Software you can easily update your VCU and display.

The PC software automatically downloads the latest data for the VCU and the display.

Quick guide:

After double-clicking on the EXE, a selection opens whether the update should be carried out via SD card or via USB. Select “SD Update” at this point. Remove the micoSD card from the VCU and insert it into your computer with the included SD card adapter.

Now click on “Flash” in the application.

Now insert the microSD card back into the VCU. Now activate the ignition on your car. First the display will update. After this is successfully completed, the VCU will be updated. Please note that the display is off during the VCU update. After the successful update the display starts as usual.

For further information please refer to the manual on page 36.

Release Notes

New Version

VCU firmware 1.0.8:
fixes:
+ General Troubleshooting
+ Loss of GNSS reception shortly after launch – improved
+ Active Sound Module Configuration – added
+ GNSS Cold Start Display* – added

New functions:
+ Setup Page 5 (ECU Ident) – added

HMI firmware 1.0.4:
fixes:
+ General troubleshooting

New functions:
+ Setup Page 5 (ECU Ident) – added

* The “Cold Start” describes the phase the GNSS receiver needs to find enough satellites to get a fix. The Cold Start currently takes about 3 minutes and is shown by “CS” next to the satellite symbol.

Previous version

VCU firmware 1.0.7:
Fixes:
+ General Troubleshooting
+ GNSS time measurement – optimized
+ wrong power indication – fixed

New functions:
+ Anglo-American measurement system – added
+ value fuel high pressure in custom dash – added
+ value fuel low pressure in Custom Dash – added

HMI Firmware 1.0.3:
fixes:
+ General troubleshooting
+ GNSS satellite display sometimes without function – fixed
+ English translation – optimized

New functions:
+ Manual reset of drag measurements – added
+ Stealth Mode – added